Trough mixer manufacturer's introduction: maintenance and principle of small mixer? Trough mixer manufacturer's analysis: some small mixers use through shaft single impeller, and the view point planning of the blade on the single impeller is very reasonable and wonderful. When the single impeller rotates, the material rolls up and down, and the blade passes through the material, and a certain pushing force occurs on both sides of the mixing tank, which makes the mixing tank at any corner The raw materials can not be stopped, so that the materials can be mixed evenly. Note of mixer manufacturer: if the reducer of small mixer is often used, it must be replaced with new oil every three months. When replacing, clean the reducer and add new oil. The shaft of bearing cover end of mixing reducer and the movable part of paddle blade are equipped with oil cup, which is smooth. During operation, grease gun is used to add butter 1-2 times per shift. Check the parts regularly 1-2 times a month, check the parts for worm gear, worm, bearing, oil seal, etc., whether the rolling is flexible, whether the fasteners are loose, and deal with the abnormal situation in time.

The small mixer adopts the sealing method of end face sealing, adjusting sealing nut and compensating axial pressure. Trough mixer manufacturer tips: small mixer in the process of operation, if found abnormal machine sensation or announced abnormal sound, should immediately stop check. Electrical control parts should be kept clean and flexible, and the defects should be corrected in time. The mixing slurry should be disassembled gently, installed stably and placed gently to avoid deformation and damage. After operation, the residual materials in all parts of the machine should be cleaned. If the machine is out of service for a long time, it must be wiped and cleaned. The surface of the machine parts should be coated with anti rust oil and covered with tarpaulin. During the operation of the small mixer, if the machine is found to be abnormal or the abnormal sound is announced, it should be stopped immediately to check. Electrical control parts should be kept clean and flexible, and the defects should be corrected in time. The mixing slurry should be disassembled gently, installed stably and placed gently to avoid deformation and damage. After operation, the residual materials in all parts of the machine should be cleaned. If the machine is out of service for a long time, it must be wiped and cleaned. The surface of the machine parts should be coated with anti rust oil and covered with tarpaulin. In addition to the functions of continuous mixing, inching mixing and active dumping, the small mixer is now equipped with the function of punctual mixing. Before mixing, any punctual time can be set and the mixer will stop at that time. It can not only save energy, but also prevent the safety accidents caused by the machine still running after the operator leaves the machine. The original base of this machine is cast iron spray paint, and now the new models are all closed with stainless steel, which meets the GMP requirements.